View Single Post
Old October 4, 2010, 07:10 AM   #10
mrappe
Senior Member
 
Join Date: January 29, 2009
Location: Texas
Posts: 213
Years ago I smoothed down the top and sides of the wedge on my 1860 Army so that I could remove it by hand. It works good but at the time I did not realize that when you do this you mess up the alignment of the barrel/cylinder gap since that is what is used to keep the barrel part in the correct position. I am now ordering a new wedge for the gun to make it stiffer since you can notice the vertical play in the barrel when applying pressure to it and the grip. The barrel moves into contact with the cylinder.
mrappe is offline  
 
Page generated in 0.05306 seconds with 7 queries