View Single Post
Old October 3, 2010, 06:33 AM   #8
monty98
Member
 
Join Date: September 30, 2010
Posts: 18
barrel

I have used 2 pieces of oak and it seemed to work. Doc i do appreciate the advice and the offer thank you. i have a couple of questions. what should the gap be between the barrel and cylinder once installed? Is there a way to make sure/measure the inner diameter of the barrel to make sure there wasn't any damage done during install, or is it ok to mic. the out side of it.
Thanks again Monty
monty98 is offline  
 
Page generated in 0.04573 seconds with 7 queries