View Single Post
Old September 25, 2010, 08:13 PM   #6
mrappe
Senior Member
 
Join Date: January 29, 2009
Location: Texas
Posts: 220
I just cast a few balls from them. I took one of the balls and put it against a Hornaday lead ball that I usually shoot and crushed them together in a bench vice. The Hornaday ball was a little softer so I tried putting one of each in the cylinder with the on pistol lever. I got the cast one in but it took a little more effort. This brings up the next question.. When is a ball too hard?
mrappe is offline  
 
Page generated in 0.04639 seconds with 7 queries