View Single Post
Old September 15, 2010, 08:18 PM   #1
kokopelli
Senior Member
 
Join Date: July 10, 2009
Location: Ky
Posts: 200
Beretta Stampede- anybody done any work on one?

I picked up a Beretta Stampede Marshall, 3.5" barrel, in 45 Colt. It is the 'Old West Antiqued Finish. The trigger on this thing is unbelievable! I've had trigger jobs done that weren't this good!
The only thing I don't like about it is the 'transfer bar' style hammer/pin setup.
Has anyone done any work on these that can tell me if I could swap out parts and install the standard Uberti 'pin-on-the-hammer setup?

I'll get picks up of mine asap, but here's what I got. Oh- the finish is much darker than the pic in the ad.

http://www.ableammo.com/catalog/bere...-p-116521.html
kokopelli is offline  
 
Page generated in 0.04354 seconds with 7 queries