View Single Post
Old September 9, 2010, 10:47 PM   #1
jimbob86
Senior Member
 
Join Date: October 4, 2007
Location: All the way to NEBRASKA
Posts: 6,744
Help ID a revolver.....

It's a 7 shot .22 DA revolver, 3 5/8" octagonal barrel, fluted cylinder 1" in diameter, cylinder pin release on front of the frame (no crane), fixed firing pin on hammer (no transfer bar), overall dimensions 7 5/8" x 3 5/8", only markings are a serial # (165***) on the front of the grip, the last 2 digits of the serial # on the rear face of the cylinder, and "HUNTER MODEL" on the top strap. It has only 2 screws, one holding the grip panels on and the other appears to be a pivot point for the hammer. There are 5 pins arranged along the front an bottom edges of the fram as viewed from either side....

Sorry, no pics....... any ideas?
__________________
TheGolden Rule of Tool Use: "If you don't know what you are doing, DON'T."

http://nefirearm.com/
jimbob86 is offline  
 
Page generated in 0.04020 seconds with 7 queries