View Single Post
Old September 7, 2010, 05:43 PM   #338
WANT A LCR 22LR
Senior Member
 
Join Date: September 5, 2010
Posts: 389
Don't have any pictures of my setup, but it consists of a Lee Pro 1000 ( yes it works fine with a little bit of care thank you ) mounted to a 3" X 3" x 6" long thick angle. The angle then clamps into the bench vise allowing for a sturdy setup that can be removed at any time. ( No, that's not a beer bottle cap crimper. . . )

The next step is going to be taking a 18 X 24 ish steel or fiberglass pan ( think lunch tray ) cut a slot in the center so the angle can pass through and then I'll have a good working surface rather than dropping down to bench top level each time I want to pickup another bullet.

As some have said on other boards, put the scale on a shelf at eye level for ease of reading.
WANT A LCR 22LR is offline  
 
Page generated in 0.06223 seconds with 7 queries