View Single Post
Old July 18, 2010, 04:00 PM   #4
IllinoisCoyoteHunter
Senior Member
 
Join Date: December 23, 2008
Location: Southern Illinois
Posts: 1,506
One hint: when casting, try not to inspect the bullets immediately after dropping them from the mold. Keep casting and keep that mold hot. Inspect after you are done casting. Sometimes beginners get too caught up looking at their bullets and their mold cools down between casts and they can't figure out why their bullets are all wrinkled and have poor fill out...

Good luck!
__________________
~~IllinoisCoyoteHunter~~

~NRA LIFE MEMBER~
~NRA CERTIFIED INSTRUCTOR~

Last edited by Shane Tuttle; July 25, 2010 at 08:29 PM.
IllinoisCoyoteHunter is offline  
 
Page generated in 0.03964 seconds with 7 queries