View Single Post
Old July 14, 2010, 05:59 AM   #9
taylorce1
Senior Member
 
Join Date: November 18, 2005
Location: On the Santa Fe Trail
Posts: 5,588
I'm not smelting in the Lee pot, I've got a larger steel pot on a turkey fryer that does my smelting work. I'm only putting back the reject bullets and sprues directly into the Lee pot. Other than that it is ingots that I've cleaned going into that pot.

I've tried turning the screw on top to get it to slow the drip and that isn't what is really bothering me. The inconsistant flow out of the spout has me bothered more than anything else. I'll try the half full method and see if that works better but it sure is a lot harder to flux the pot when it is only half full.

Thanks for the replies.
taylorce1 is offline  
 
Page generated in 0.04392 seconds with 7 queries