View Single Post
Old July 2, 2010, 07:52 PM   #4
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,338
There should be a mark on the cocking piece which will line up with the slot in the firing pin when it is right. It the firing pin is off a half turn it should be obvious as it will be below or above the surface of the cocking piece. When the two parts are flush and the marks line up, the protrusion should be correct.

Jim
__________________
Jim K
James K is offline  
 
Page generated in 0.04053 seconds with 7 queries