View Single Post
Old July 1, 2010, 12:20 PM   #1
Boomer8404
Senior Member
 
Join Date: February 3, 2007
Location: Far West Texas
Posts: 108
Finishing Question?

OK, so Ive got my new to me Glock 23 that I did a little frame sanding on. I tend to have a really high hold on the grip so naturally I suffer from the "Glock Knuckle" on my middle finger because of the blocky trigger guard, so I decided to carefully take a Dremel with a sanding drum to it. I now have it adjusted like I want it and was wondering if anyone knew of a good way to shine the plastic back to match or closely match the rest of the polymer factory finish. I was thinking of carefully and slowly rubbing the area with a little acetone, what do yall think. Thanks for any ideas.
Boomer8404 is offline  
 
Page generated in 0.05904 seconds with 7 queries