View Single Post
Old June 28, 2010, 01:23 PM   #5
denster
Senior Member
 
Join Date: April 24, 2010
Location: Ohio
Posts: 464
It depends on your gunsmithing ability. You do give up a significant amount going with Pietta over Uberti. That said you can make the Pietta into the equal of the Uberti if you don't mind smoothing all of the internals and reshaping the arbor wedge slot and the wedge so it works properly which is allready done on the Uberti. With the Uberti you may have to do a little work to get it as smooth as you like but not nearly as much and the wedge itself may be good from the box, at worst you may have to remove a few thousandths from the tapered edge towards the muzzle.
denster is offline  
 
Page generated in 0.05851 seconds with 7 queries