View Single Post
Old June 26, 2010, 02:15 PM   #2
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
If you're referring to a wear line around the outside of the cylinder between the indexing notches, it is an indication that the revolver is out of time and raising the stop latch too early, letting it drag on the cylinder outer surface ILO into the notch's leade.

A revolversmith should be able to remedy the timing, but only a cylinder refinish will remove the evidence.

.
PetahW is offline  
 
Page generated in 0.04099 seconds with 7 queries