Thread: Bolt drag
View Single Post
Old June 21, 2010, 12:45 AM   #9
denster
Senior Member
 
Join Date: April 24, 2010
Location: Ohio
Posts: 464
Smokin Gun. I now you've been at this a spell and so have I. You are correct it will drop the bolt head height, but only where you don't want the height dropped ie: full cock and hammer down. Think about the cycle for a bit and you will see what I mean. It will not drop the bolt head lower as the weapon is cocked as that is controled solely by the hammer cam contact with the bolt leg and nothing else. It will lighten somewhat the spring pressure against the bolt as the cylinder drags by but it does not correct the problem.
denster is offline  
 
Page generated in 0.04081 seconds with 7 queries