Thread: Bolt drag
View Single Post
Old June 20, 2010, 11:27 PM   #5
denster
Senior Member
 
Join Date: April 24, 2010
Location: Ohio
Posts: 464
A drag line "around" the cylinder is the result of the bolt not retracting far enough to completely clear the cylinder. Lowering the hammer on the safety pins will not cause a drag line if done properly. With the hammer still in half cock line up a pin in the hammer notch then lower the hammer. The bolt will rise and be against the cylinder but when you cock the pistol the bolt will have retracted before the hand picks up the ratchet to start revolving the cylinder.
denster is offline  
 
Page generated in 0.04210 seconds with 7 queries