Thread: Bolt drag
View Single Post
Old June 20, 2010, 09:00 PM   #2
Model-P
Senior Member
 
Join Date: February 24, 2009
Posts: 727
With the gun disassembled (cylinder removed), place the gun on half cock. You should be able to see if the bolt is fully retracted into the frame or not.

If you lower the hammer from half cock (such as when using the safety pins) you will create a drag line. If this bothers you, always fully cock the hammer before lowering it again, and forget about using the safety pins. Just keep the hammer lowered on an empty chamber.
Model-P is offline  
 
Page generated in 0.04556 seconds with 7 queries