View Single Post
Old December 2, 2000, 09:50 PM   #10
photoman
Member
 
Join Date: December 26, 1999
Posts: 22
I've been experimenting with the Redding Profile Crimp die for my .44 special loads lately and have been very happy. I have had some trouble getting my .44 mag loads to crimp heavy though. It is my understanding that the Redding die does NOT put a heavy roll crimp (like I'm used to seeing on .44 mag loads) but it rather puts a taper and then a mild roll crimp. My loads so far do not have a heavy looking roll to them and if I crank down the die further, it begins to "cut" the brass. Just wanting to make sure I'm doing it right. Thanks.
photoman is offline  
 
Page generated in 0.04043 seconds with 7 queries