View Single Post
Old June 15, 2010, 12:06 AM   #314
DocAitch
Member
 
Join Date: March 16, 2010
Location: North of Baltimore
Posts: 60
Here's mine. The lower bench to the right is the third generation, the taller to the left is the second generation. Putting the step plugs in the center of the bench and using C clamps gives better support for the rear of the press mounted on 2x6".
No machining skills and only basic rough carpentry skill were required to build this bench. There is literally 3 minutes between shot #4 and shot #5 below.
DocAitch


Shot at 2009-11-13


Shot at 2009-11-13


Shot at 2009-11-17


Shot at 2010-05-16


Shot at 2010-05-16
DocAitch is offline  
 
Page generated in 0.04672 seconds with 7 queries