View Single Post
Old June 10, 2010, 06:54 PM   #1
Deputy Dog
Senior Member
 
Join Date: June 12, 2009
Posts: 247
Colt 1911 LW Commander 9mm

I noticed that the gun hasnt been fired that much, I just had a well known 1911 Smith do a long trigger & trigger job, a beavertail and thumb safety. I noticed the action is kind of rough to say the least. It has factory parts except for the forementioned work done to it. Is there anyway I can make the action a little bit smoother before I take her to the range? Or do you think she just needs some range time to break her in? I was wondering if I should polish the throat a little and maybe the reels of the frame and slide?
Any suggestions is greatly appreciated.
Thank you,

DD
Deputy Dog is offline  
 
Page generated in 0.04430 seconds with 7 queries