View Single Post
Old May 29, 2010, 04:38 PM   #1
HeadShotsOnly
Junior Member
 
Join Date: May 29, 2010
Location: Texas
Posts: 12
Trigger pull on an HK91?

First off, please allow me to introduce myself, as I am new here. I'm an avid shooter, builder, and hunter from the Great State of Texas.

Anyhow, I have been a builder of AR15 rifles for a while, and just recently stepped up to the bigger-bore realm of the HK91. I've had it for about a month now, and have made only two mods to it so far...

I mounted a swivel stud purchased from the local Academy onto a piece of flat bar, riveted said flatbar to an extra forearm, and now I have a bipod mount that doesn't require using an actual HK piece or some cheap knock-off.

Last night, using "Super-Sculpee" polymer clay, I molded a pistol grip that is an exact casting of my right hand, which fits perfectly and puts the tip of my finger right where it needs to be.

I went to the range today to test out these two additions, and found my next area of concern. The trigger pull on this thing is just atrocious! Seriously, I stopped shooting after three mags because my finger just felt worn out!

Is there anyone out there who can tell me how to lighten the pull on this thing, or direct me to an aftermarket trigger setup?

-Barry
HeadShotsOnly is offline  
 
Page generated in 0.04232 seconds with 7 queries