View Single Post
Old May 20, 2010, 06:34 PM   #2
dksac2
Member
 
Join Date: May 17, 2010
Posts: 62
Once you have the grip panels off, I assume you are talking about the large pin that goes through the grip.
Spray a little penatrating oil on it, let it sit for a while.
Then get a punch that fits the pin, put the grip on a pin block (or piece of wood with a hole drilled into it for the pin) and hit the punch with a BFH (Big Friggin Hammer). It will come out, you just need to hit it hard enough.

Best regards, John K

Last edited by dksac2; May 20, 2010 at 06:42 PM.
dksac2 is offline  
 
Page generated in 0.05346 seconds with 7 queries