View Single Post
Old May 19, 2010, 03:28 PM   #14
ClemBert
Senior Member
 
Join Date: March 2, 2009
Location: Orlando
Posts: 929
zippy, my ClemBert Pin was made specifically for my conversion cylinder so I could very quickly remove the conversion cylinder, reload, and re-install it. It is unlikely that I'd have a chainfire with my 45 Colt reloads. I use a factory retaining pin when shooting cap-n-ball style. Thus, my comment on a potential holster issue as being the primary issue for me....but...I don't holster....yet. IF I had a holster and IF I had a hangup issue I'd probably reduce the size of the finger grip (the washer) on my ClemBert Pin. Then it would not get hung up in a holster. Your idea of using a wire type loop is interesting.
ClemBert is offline  
 
Page generated in 0.05754 seconds with 7 queries