View Single Post
Old May 13, 2010, 09:55 AM   #26
Senior Member
Join Date: May 3, 2007
Location: Virginia
Posts: 420
Reaming out a welded chamber would be unpredictable and likely result in a sloppy chamber. The rifle in question would most likely be fine with a new barrel, but then there is the issue of cost to re-barrel against cost of a ready to shoot rifle.
Don't focus so much on who is driving the bus, but pay attention to what bus you're on and where it's going.
apr1775 is offline  
Page generated in 0.04774 seconds with 7 queries