View Single Post
Old April 25, 2010, 04:41 PM   #7
mrawesome22
Senior Member
 
Join Date: November 9, 2005
Location: Ohio, Appalachia's foothills.
Posts: 3,779
Quote:
I did place an empty fired case in the chamber and it chambered nice and easily and smoothly.
Then it could be either the brass on the neck is too thick, or you have a tight necked chamber. Have you ever cleaned the chamber of this rifle?
Quote:
I have cleaned the bore well multiple passes with my bore snake and oils and what not.
This is not going to cut it. To properly clean a rifle bore, you will need a bore guide, a one piece rod, brushes, jags, patches and copper and fouling solvents. Those bore snakes are good for 22's. That's about it.
mrawesome22 is offline  
 
Page generated in 0.05702 seconds with 7 queries