View Single Post
Old April 21, 2010, 03:40 PM   #3
mykeal
Senior Member
 
Join Date: October 8, 2006
Location: Northern Michigan
Posts: 2,754
I push it in with my fingers and then, depending on the the cylinder to forcing cone clearance, use wood head hammer to gently tap it further through. Different guns require different amounts of effort. The 'correct' position I aim for is the one that gives a cylinder to forcing cone function clearance of about 0.006".
mykeal is offline  
 
Page generated in 0.04359 seconds with 7 queries