View Single Post
Old April 7, 2010, 11:09 PM   #3
10 Spot Terminator
Senior Member
 
Join Date: January 3, 2008
Location: Central Oregon
Posts: 346
I got one reply on another forum and was told it was more trouble than it was worth that both the front sight and the bayonet lug were pinned to hold them in place then either epoxyd or soldered in place. It will take much work with a torch and a good vise to hold the action in place while either trying to knock the offenders off and may require some careful cold chisel work. I am not easily scared and will start on this project soon.
10 Spot Terminator is offline  
 
Page generated in 0.04403 seconds with 7 queries