View Single Post
Old March 8, 2010, 02:57 PM   #8
thallub
Senior Member
 
Join Date: November 20, 2007
Location: South Western OK
Posts: 2,089
I heat the screw with a micro torch. This releases the Lock Tite. Then a reverse twist drill bit is used to take out the screw. After a few revolutions of the drill the broken screw usually starts to turn.

http://www.irwin.com/irwin/consumer/...rwinProd100128
thallub is offline  
 
Page generated in 0.03921 seconds with 7 queries