I waited all week for my shipment containing:
Lead pot, Sizer, Liquid alox , Thermometer & Bullet Mold
I open the box and start reading the Bullet mold instructions. It says:
"lubricate your mold. Very Lightly touch bullet lubricant to the spruce busing "V" ribs and locating cross pins. Use Lee Lube #90007. Do not use liquid Alox as it will bake onto the surface preventing proper closure."
Ok I am dead in the water... I only have Liquid Alox.
My question Is: Is there a substitute compound I can use to lube the mold.