View Single Post
Old December 14, 2009, 04:17 PM   #10
80viking
Senior Member
 
Join Date: December 8, 2009
Location: The Peoples Republic of Massachusetts
Posts: 311
sirusa, here's what I did to get my 22-250 M98 to feed properly, your follower and spacer block will have to be sized accordingly for your caliber, for the follower, I cut the extra material off behind the magazine spring, it now measures 2.450'' long, you'll have to cut an angle on the top rib of the follower so the bolt will close on an empty magazine, the block I used measures 1.4'' H x .87'' x .75'' this is attached with a rivet or a sheet metal screw going in above the trigger cut out in the rear of the magwell, make sure the block is left high enough for the floor plate to snap in ,hope this helps
80viking is offline  
 
Page generated in 0.04571 seconds with 7 queries