Thread: molds
View Single Post
Old November 12, 2009, 03:39 PM   #5
hornady
Senior Member
 
Join Date: April 6, 2009
Location: SWPA
Posts: 428
Batman I was not trying to blow you off with my reply. I have cast bullets for over 30 years. Just like reloading, there are many things that must be taken into consideration. From slugging the barrel to Alloy used. A lot of guys buy the Lee molds without sizing and tumble lube with no problem. Others need to size. It all depends on the slugged diameter of your barrel, Also Alloy used will affect the as cast Diameter of a Bullet. The manuals I recommended. Are cast Bullet specific. And will get you started in the right direction. Plus they are full of cast load information
hornady is offline  
 
Page generated in 0.04461 seconds with 7 queries