View Single Post
Old October 19, 2009, 11:59 AM   #3
Jector
Member
 
Join Date: September 24, 2009
Posts: 85
Thanks for the reply! I removed the receiver from the stock and found a matching ser. number stamped in the stock, that's when I realized it was probably cut down. It does have all matching numbers, every screw, but it is chopped up. This did have a scope on it which explains the bent bolt handle. The front lug(?), about 4 inches back from the muzzle was cut off too, and soldered poorly back where the sling connects at the front. It simply fell off when I disassembled the rifle.
Jector is offline  
 
Page generated in 0.04255 seconds with 7 queries