View Single Post
Old September 25, 2009, 01:40 AM   #2
jimkim
Senior Member
 
Join Date: July 3, 2008
Location: middle GA
Posts: 319
You can use Veral Smith's Blue Soft, pan lube or tumble lube. They all work. You can also use a wax toilet ring, or Johnson's Paste Wax.

http://www.youtube.com/watch?v=V_vYYoArHtE

Tumble lube instructions:

Quote:
Lead bullets require lubrication to prevent them from depositing lead in the bore when shooting. There are many types of bullet lube. Traditionally, a stick of hard wax bullet lube is used in a lubrisizer to lubricate the bullets as they are sized. It's a bit messy, but the lube works well. For less mess and lower cost, tumble lube bullets using a thick liquid bullet lube. This works best if the bullets have tumble lube grooves or micro bands. Instead of two thick drive bands on the shank and a thick lube groove in between, bullet molds designed for tumble lubing have a few smaller drive bands with a few smaller lube grooves between them, providing more surface area for the thick liquid bullet lube. The tumble lube process is simple. Dump the sized bullets into a plastic container and add a blob of liquid bullet lube. About a teaspoon is sufficient to lubricate 200 bullets in the 9mm to 10mm range. Put the lid on the plastic container and shake, rock & roll until the bullets have a uniform coating. This only takes a minute. Pour the bullets out on an old cookie sheet in a layer one bullet deep to dry overnight. With tumble lube, the sticky lube is applied to the entire bullet and not just the lube grooves on the shank where it's needed. This makes handling the bullets a bit messy when reloading ammo, and loading ammo at the range. Sprinkling a teaspoon of powdered mica over the bullets will help keep the bullet lube on the bullets.
http://www.tacticoolproducts.com/bulletcasting/

You can use this same method to apply "toilet wax".
Quote:
Blue soft can be wiped into the grooves with a bit of lube on the index finger of the master hand, then hold that finger out of the way as you use that hand to push the bullet through a Lee sizer, or seat into your ammo without sizing. I find finger lubing far less messy and much faster than the cake cutter method, having loaded thousands of rounds this way. When I do it, I visually inspect the bullet, apply lube, only in the last groove for lighter loads, and seat the bullet. It goes surprisingly fast with little bullet handling.
http://www.go2gbo.com/forums/index.p...c,85250.0.html

Johnson Paste Wax:
Quote:
I put bullets (approx 50) either PB or GC'd into a plastic jar and mix shaved (very thin) scented candle, and about 2 tablespoons of JPW into the jar. The turp. or ???? disolves the parafin no heat source needed. Shake this mess around for about a minute and lay out the proj's on a doubled upped sheet of foil. Air dry for about 24 hours. PB's under 1400, and GC's at approx 1650 foot seconds. My personal experience has been no leading and accuracy is as good as the operator can shoot. posted by Gwindisch
http://www.castbulletassoc.org/forum...77&forum_id=16


>Maybe this answered a few questions. Jim
__________________
Jan. 4, 2007 gasoline $2.10 gal....HMMM?
jimkim is offline  
 
Page generated in 0.04880 seconds with 7 queries