View Single Post
Old September 6, 2009, 08:57 AM   #2
IllinoisCoyoteHunter
Senior Member
 
Join Date: December 23, 2008
Location: Southern Illinois
Posts: 1,505
I would lube and shoot them as cast. .002" over groove diameter, especially with the tumble lube style bullet, is no problem. When you size it, you are eliminating and area for the LLA to sit, which may cause some leading. If your pistol doesnt like them at .002" over, then I know a guy that would be able to make you a custom push thru sizer die at .359". As long as they load ok, they should shoot just fine as cast. I would definately start you load development over....start with the starting load and work up (I know, you already knew this!!!) Good luck!
__________________
~~IllinoisCoyoteHunter~~

~NRA LIFE MEMBER~
~NRA CERTIFIED INSTRUCTOR~
IllinoisCoyoteHunter is offline  
 
Page generated in 0.04333 seconds with 7 queries