View Single Post
Old April 28, 2009, 06:51 PM   #8
jaguarxk120
Senior Member
 
Join Date: February 28, 2008
Location: Michigan
Posts: 1,991
The 88 Commission rifle has a barrel shroud. The actual barrel is quite thin. What the gunsmith meant was to put the barrel in a lathe and face off the breach end to decrease the headspace. And then re install the barrel. The barrel has to be shortened enough to correct the headspace. The sights are carried on the shroud.
jaguarxk120 is offline  
 
Page generated in 0.04194 seconds with 7 queries