View Single Post
Old March 11, 2009, 06:43 PM   #1187
Radagast
Senior Member
 
Join Date: July 13, 2001
Posts: 449
Gurn: Those are British proof marks. What you have may be a .38 S&W British Service revolver (WWII made on the K frame, concurrent with the Victory model) that later has the chambers bored through to allow .38 special to be chambered. If the there is a slight taper to the rear of the chambers then this is possibly the case. If so stick to standard pressure loads as there is a chance that that higher pressure ammunition will split the cases.
Radagast is offline  
 
Page generated in 0.05177 seconds with 7 queries