View Single Post
Old February 22, 2009, 02:16 PM   #2
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,128
It is probably metric to begin with. I would simply take a good look or make an impression with wax or modelling clay, then buy one or two each of screws that look right. At ten cents or so each, what can you lose?

Then bring them home and see if one works. (You might have to cut it to length or reshape the head.) Most European makers use standard metric thread sizes.

Jim
__________________
Jim K
James K is offline  
 
Page generated in 0.04575 seconds with 7 queries