View Single Post
Old February 19, 2009, 05:23 PM   #2
wachtelhund1
Senior Member
 
Join Date: January 4, 2007
Posts: 120
TFountain, No advice for a gunsmith but I think most gunsmith should be able to handle the silver soldering. Problem will be not messing up the finish. What do you use for scope base? I have a mint H&K 300 which I purchased just over a year ago. With what I paid for it I wish I had purchased mine in 1985. I could not find an 05 mount, so had a weaver ruger 10/22 base milled flat on the bottom and drilled to match the aligment thread holes in the bases. I used extra long screws that went through the bases into the receiver itself. Not a stock H&K 05 mount, but then it only cost $10.00 and is fast to the receiver.
wachtelhund1 is offline  
 
Page generated in 0.04766 seconds with 7 queries