View Single Post
Old January 22, 2009, 12:15 AM   #413
HUBEL458
Senior Member
 
Join Date: March 8, 2000
Posts: 593
You can make big holes you can see easy.

RIP on AR forums been testing starter powders loads, with
shotgun primers,with Blue Dot starter and HBMG main load. And
I just tested some variety of ones myself.
Doing some testing with starter powder, 15gr Blue Dot, with
slower powders that fill the cases with minimum wads.
Tested in 3.5" RMC case in NEF with shotgun primer,
with 36" added to barrel.Remember I have extra foot of bbl.

These 4 top loads expanded case, where I check it, just above
thick base section to .811" from .807" resized.

1000gr jacketed, 230gr HBMG, 1800 fps, 7200 ft lbs,
with 1/8" card and 1/4" felt wad.

715gr jkt, 270gr HBMG, 2200, 7600 ft lbs, 1/8" card.

600gr Dixie, 250 gr Retumbo, 2400, 7600 ft lbs, 1/8" card.

385gr jkt AL core, 250 gr RL25,2900, 7200 ft lbs.

Now the starter powder loads, which a few guys like, increase
powder speeds so that HBMG acts like RL25. In first example,
with 1000 gr in RMC case you couldn't use 230gr of RL25
as that would expand RMC brass too much and stick the case.
A few guys have found that slow powder, with starter
powder is easiest for 1000gr and heavier loads.

On another note, I've heard around the grapevine that if
enough of us ask for NEF to make available a 12ga Ultra with
a 28" rifled bull barrel that they would do it.Start calling
folks, maybe do some good. Just tell them these new sabot
and fullbore slug loads need more barrel to get the velocity
out of them. 1-866-776-9292. Ed
__________________
ED HUBEL

Last edited by HUBEL458; January 22, 2009 at 07:48 PM.
HUBEL458 is offline  
 
Page generated in 0.04429 seconds with 7 queries