View Single Post
Old December 28, 2008, 03:47 PM   #75
JayCee
Senior Member
 
Join Date: March 20, 2001
Posts: 439
I really envy you guys who have a reloading "bench". I don't have enough space to dedicate to a proper bench, so I set up my presses on a grinder stand, and keep my dies, scales, priming devices, etc. in a Craftsman tool chest:



The whole rig rolls into the closet in my study when not in use:



I can sit at my computer while reloading in case I need to check any load data, so the setup works well for me.
__________________
“You may all go to hell and I will go to Texas.” – David Crockett

“If I owned Texas and hell, I'd rent out Texas and live in hell.” - General Phillip H. Sheridan

Last edited by JayCee; December 28, 2008 at 03:53 PM.
JayCee is offline  
 
Page generated in 0.04757 seconds with 7 queries