View Single Post
Old December 24, 2008, 12:48 PM   #17
claymore1500
Senior Member
 
Join Date: May 20, 2008
Location: northcoast, Ohio
Posts: 241
"sniper scope milling"

The area on your reciever (left side, rear) there are two screws just below the reciever cover, the holes and the groove in the reciever in that area is where the sniper scope mount attached, although your wood is not cut for the mount.
claymore1500 is offline  
 
Page generated in 0.05126 seconds with 7 queries