View Single Post
Old November 13, 2008, 12:52 AM   #12
gunn308
Member
 
Join Date: October 4, 2006
Location: Maine
Posts: 73
This shouldn't be happening I own three 10/22s and only had fail to eject and feed with one and that was using subsonics, polished bolt return rod and put a slight radius on bolt because this is my squirrel gun and quiet is a plus have not had any problems since and that is with a few bricks through each. Follow Mr. Bonars advice he is a knowledgeable person, 25 inch/pounds of torque is all that is needed on those barrel and action screws as these are steel screws that go into aluminum.
__________________
Oats that have already gone through the horse are always cheaper than oats that haven't !
gunn308 is offline  
 
Page generated in 0.05234 seconds with 7 queries