View Single Post
Old November 9, 2008, 03:08 AM   #1
2ndchance
Senior Member
 
Join Date: March 21, 2008
Location: Glendale, AZ
Posts: 156
total disassembly of a SIG slide

I'm planning on refinishing my Sig P225/P6 slide. I would like to break the slide town and remove everything so I end up with a gutted/hollowed-out slide. So, here's my question.

1. When drifting the sights off the slide, does it matter which way I tap them (left or right)?

2. When I press out the roll pin in the back, will this allow the entire underside (holding the firing pin and breech face) slip out or is there something else in there holding onto it.
__________________
"It's better to be prepared, than scared."

Explaining the 2nd Amendment
2ndchance is offline  
 
Page generated in 0.04901 seconds with 7 queries