View Single Post
Old November 2, 2008, 11:41 PM   #377
HUBEL458
Senior Member
 
Join Date: March 8, 2000
Posts: 580
I took Brenekke KOs out of factory cases and shot them at
2700+ fps. Seem to work fine- hits straight, hardly any lead on
rifling..I think the heavy plastic base picks it up.

Been testing the Encore with the Nef loads. Barrel breech is
one inch same as muzzle, where the NEF is 1.200".
It has dovetails cut out in bottom of the barrel for
the nuts for the forearm screws. ... At the bottom of dove tail
there is only .060" thickness. Before reaming had back one fill
welded as it was where the taper for the forcing cone ended up
with 3.5" chamber. I load it with 10 gr less powder than the NEF
on all different slugs and weights. Like the BPI sabot in 3.5"
plastic in NEF, 437 gr slug, 120gr 4227, 2400 fps, and in Encore
110gr 4227, 2270 fps. In 3.5" RMC brass case, same sabot/slug
in NEF 140gr 4227, 2600+ fps,Encore 130gr 4227, 2500.
The Encore is now 12 lbs, with hollow in butt and recesses in
forearm with lead shot.In pic you see NEF And Encore with RMC
brass cases started in chambers. Ed

__________________
ED HUBEL
HUBEL458 is offline  
 
Page generated in 0.04263 seconds with 7 queries