View Single Post
Old October 29, 2008, 04:25 AM   #6
Raider2000
Senior Member
 
Join Date: July 23, 2007
Location: Virginia
Posts: 717
I know that the R&D cylinders you would have to remove the cylinder from the frame & remove the rear cover plate that houses the firing pins & a locating notch, then insert the 5-6 rounds into the cylinder reinsert the plate "it only goes on one way" & then reinsert the cylinder assembly into the frame of your pistol.
Raider2000 is offline  
 
Page generated in 0.04513 seconds with 7 queries