Thread: Lathe
View Single Post
Old October 22, 2008, 12:57 PM   #4
Harry Bonar
Senior Member
 
Join Date: December 5, 2004
Location: In the Vincent, Ohio general area.
Posts: 1,804
lathe

Sir;
I've used Grizzly for years now and am totally satisfied. However, if I was you, as Nick says, I'd get the 12X36 lathe for about $2200.00 - mine only runs out .001 on the three jaw chuck!
Recently bought the mill from Grizzly and it's a monster that just eats steel. It is capable of extremely precision work also.
Both of these machines come with everything, except cutters. They are of excellent quality even though made in China!
Their warranty is very good, and the markings on the hand wheel dials are accurate.
Harry B.
Harry Bonar is offline  
 
Page generated in 0.05574 seconds with 7 queries