View Single Post
Old October 1, 2008, 07:41 AM   #2
Jim Watson
Senior Member
 
Join Date: October 25, 2001
Location: Alabama
Posts: 10,982
If you have the right rib, all that has to be done is remove the front and rear sights, then drill and tap two holes. No need to remove the rib from the factory barrel. IF you have the right rib. If you don't, more work might be required.

Note that Bomar is out of business and these sights are no longer made.
Jim Watson is offline  
 
Page generated in 0.05144 seconds with 7 queries