View Single Post
Old September 23, 2008, 05:32 AM   #7
shortwave
Senior Member
 
Join Date: December 17, 2007
Location: SOUTHEAST, OHIO
Posts: 5,936
Had sort of the same problem with my old T/C Hawkins 50 cal.Years ago sent it to a friend of mine to have engravings and ivory inlaid in stock. For some reason when I got it back it shot same PRB,powder load extremely high. This smokepole was a tackdriver prior to getting stockwork done. With rear site adjusted as low as it would go,still shot very high. I ended up removing front sight, welding a taller bead(doesn`t take much) on original site and dressing it down to my liking. Its again a tack driver with rear site adjusted in middle.
shortwave is offline  
 
Page generated in 0.04396 seconds with 7 queries