View Single Post
Old September 22, 2008, 12:23 PM   #2
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,682
I can't be sure, but I suspect the hammer was on the soft side, or work on it cut though case hardening. In any case, normal firing causes the hammer to drop on the sear very quickly, and the sear cut into the hammer notch, leaving a groove that increased the trigger pull. If that is the case, examination of the hammer notch under magnification may bear it out.

Jim
__________________
Jim K
James K is offline  
 
Page generated in 0.04304 seconds with 7 queries