View Single Post
Old September 20, 2008, 07:37 PM   #4
Dfariswheel
Senior Member
 
Join Date: May 4, 2001
Posts: 6,822
Since the barrel is welded on, there's no way to get the forearm off without cutting it.

The forearm is normally removed by unscrewing the round slotted nut inside the front end.
With the barrel in place and the barrel support ring in front of the forearm, there's simply no way to get to the nut.
With the nut in place, there's no way to remove OR install the forearm unless you cut it in half.
Dfariswheel is offline  
 
Page generated in 0.04528 seconds with 7 queries