View Single Post
Old September 14, 2008, 09:36 AM   #22
Playboypenguin
Junior member
 
Join Date: February 27, 2006
Location: Great Pacific Northwest
Posts: 11,515
Quote:
How far do you break down a revolver for blasting?
What about masking and cleanup?
Anything that moves gets removed. Hammers, springs, triggers, etc.

There is not a lot of masking needed unless the gun is going to be two tone.

For clean up I first use a air nozzle to blast all the sand out at about 135psi. Then I spray down every nook and cranny with cleaner to flush out any stubborn sand and then blast it with the air hose again. Finally I go over everything with a Q-tip and take a pick to the crevices to be sure.
Playboypenguin is offline  
 
Page generated in 0.04135 seconds with 7 queries