The Firing Line Forums - View Single Post

Bill DeShivs · September 7, 2008, 02:33 PM

The hard part about cutting springs is knowing when to stop. If you have replacement springs handy it doesn't matter if you cut too much off-you can just start over. If you don't have replacement springs it's best to err on the side of caution.

September 7, 2008, 02:33 PM	#3
Bill DeShivs Senior Member Join Date: April 7, 2006 Posts: 6,457	The hard part about cutting springs is knowing when to stop. If you have replacement springs handy it doesn't matter if you cut too much off-you can just start over. If you don't have replacement springs it's best to err on the side of caution. __________________ Bill DeShivs www.billdeshivs.com